Precautions During The Operation Of Metal Shredder Machine

1. Do not stop immediately after the work is finished. It should be idling for 2-3 minutes to allow the material in the Metal Shredder Machine to be completely discharged. Cleaning and maintenance work should be carried out after shutdown.

2. The hammer piece is the main wearing part. After the wear, whether it is changing the corners in the same direction or changing the corners, the whole group of hammers should be exchanged at the same time. When replacing the new hammer, the whole set of hammers should be replaced at the same time. Replace with old ones. The screen is also a wearing part. If some of the screen is damaged, it can be riveted. If it is badly damaged, it needs to be replaced with a new one.

3. After 300 hours of Scrap Metal Shredder operation, the bearings should be cleaned and the oil changed. The belt should be removed when parking for a long time. Safety and operation procedures: operators must be educated by safety technology before they can operate on the machine.

(1) It is strictly forbidden to peep into the machine from the upper part of the crushing chamber during operation.

(2) Electrical equipment should be grounded, and the wires should be insulated and installed in the steel pipe.

(3) It is strictly forbidden to carry the moving materials directly in the crushing chamber after the feeding port during operation.

(4) The grinder is strictly forbidden to make any adjustment, cleaning or overhaul work during the operation.