Common Problems And Solutions Of Industrial Metal Shredder

The motor smokes and the fuse blows: the feed is too much, the crushing chamber of Industrial Metal Shredder is clogged, the motor is overloaded, the feeding should be stopped, and the feeding should be resumed when the normal state is restored; the sieve hole is blocked, the crushing room material can not be discharged, and the power should be shut down. Open the case and clean the sieve before putting it into operation.

The crusher vibrates violently: the hammers are installed in the wrong order; the individual hammers are not opened to make the hammers flexible; the spindle is bent, and the spindle is corrected or replaced.

The crusher is blocked: the feed rate is too fast, the load is increased, and the blockage is caused. During the feeding process, it is necessary to pay attention to the deflection angle of the ammeter pointer. If the rated current exceeds the rated current, it indicates that the motor is overloaded, and the motor will burn out if it is overloaded for a long time. If the discharge pipe is not smooth or the feed is too fast, the sawdust crusher will be cut. The tuyere is blocked; improper matching with the conveying equipment will cause the discharge duct wind to weaken or block the wind after no wind. After the problem is detected, the delivery equipment that does not match the delivery port should be cleared, and the feed amount should be adjusted to make the equipment operate normally.

There is a strange sound in the smashing room of metal crusher machine: the parts inside the machine fall off or the parts are stopped to check the replacement parts; the speed is too low or the belt slips to ensure the speed and tighten the belt; the hard stone enters the machine and stops to remove the hard objects.